This is to show you how to use the pre-programmed functionality of the Joey Micro6. If customising or re-programming, please refer the standard Joey programming manual.
Entering ‘preset mode’ on the Joey Micro6
- Remove power from the Joey Micro.
- Hold down the two buttons shown in the diagram.
- Apply power to the Joey Micro while continuing to hold the two buttons.
- Keep holding the two buttons for six seconds.
- Once preset mode has been entered use the number keys 1, 2, 3 and 4 to enter the desired 4-digit preset code as shown on the following page.
- Once you have entered 4 digits, the pattern of LEDs will change. The LED pattern should match the pattern shown on the following page. This is to verify that the correct preset has been selected.
- If the selection is correct, press the OK button. The Joey Micro will beep afterward it will restart with the new configuration installed.
Code indicators description
1111 o - - Dell
- - -
1112 - o - Epson
- - -
1113 o o - Hitachi
- - -
1114 - - o Mitsubishi
- - -
1121 o - o Nec 19200 baud
- - -
1122 - o o Nec 38400 baud
- - -
1123 o o o Optoma
- - -
1124 - - - Sanyo
o - -
1131 o - - Sharp
o - -
1132 - o - Panasonic
o - -
